š Free Worldwide Shipping on All Orders!Shop Now
Domehead Fine 7mm
PermaGrip Domehead Fine 7mm
Ā 
Rotary Domehead Fine finishing Grit,Ā parallel sides, enlarge and clean holes.
Ā
Shaft / arbor 3.1 mm (1/8")
Overall length 40mm
Gritted length 16.5mm
Widest point 7mm
(all measurements are approximate)Ā
The FINE ROTARIES enables the user to cut thin, and fragile materials, leaving the best finish.Ā Also, use them to debug rough cut or sawn edges.
Ā
Our Rotaries have an integral arbor, enabling them to be used in reversible drive tools.Ā
They allow the user to cut a wide range of materials quickly and cleanly leaving an excellent finish. All rotaries are ideal for routing, shaping, and removing materials without tearing or clogging.
Use on all Woods, Glass Fibre, Carbon Fibre, PCB, Kevlar, Plexiglas, Lexan, Perspex, Acrylics, Plastics, Polystyrene, Ceramics, etc.
Excellent on Perspex, Plexiglass, Lexon, use below 10,000 RPM and they will not melt, crack or chip them. (not recommended for use on metal)
Note Rotaries should be fully inserted into the chuck and tightened before using. Maximum RPM 20,000 Low - Medium.
SAFETY:- Always wear protective goggles when using Rotary Tools.
IMPORTANT:- Carbon Fibre should not be cut using an electric drill, because of the possibility of electrocution.
$5.10
Original: $17.00
-70%Domehead Fine 7mmā
$17.00
$5.10Product Information
Product Information
Shipping & Returns
Shipping & Returns
Description
PermaGrip Domehead Fine 7mm
Ā
Rotary Domehead Fine finishing Grit,Ā parallel sides, enlarge and clean holes.
Ā
Shaft / arbor 3.1 mm (1/8")
Overall length 40mm
Gritted length 16.5mm
Widest point 7mm
(all measurements are approximate)Ā
The FINE ROTARIES enables the user to cut thin, and fragile materials, leaving the best finish.Ā Also, use them to debug rough cut or sawn edges.
Ā
Our Rotaries have an integral arbor, enabling them to be used in reversible drive tools.Ā
They allow the user to cut a wide range of materials quickly and cleanly leaving an excellent finish. All rotaries are ideal for routing, shaping, and removing materials without tearing or clogging.
Use on all Woods, Glass Fibre, Carbon Fibre, PCB, Kevlar, Plexiglas, Lexan, Perspex, Acrylics, Plastics, Polystyrene, Ceramics, etc.
Excellent on Perspex, Plexiglass, Lexon, use below 10,000 RPM and they will not melt, crack or chip them. (not recommended for use on metal)
Note Rotaries should be fully inserted into the chuck and tightened before using. Maximum RPM 20,000 Low - Medium.
SAFETY:- Always wear protective goggles when using Rotary Tools.
IMPORTANT:- Carbon Fibre should not be cut using an electric drill, because of the possibility of electrocution.
